Lexmark X734DE - Reset Fuser Count; USB Scan to Local

Diagnostic aids 3-31
7526
Go Back
Previous
Next
Reset Fuser Count
Resets the fuser count value to zero. The Event Log records each time that a user executes the Reset Fuser
Count operation. See “Event Log” on page 3-33 for more information. This setting only appears if the
Maintenance Warning and Intervention function is enabled in the printer Configuration ID.
To reset the fuser count:
1. Touch Reset Fuser Counter from the Config Menu.
2. Touch Reset Fuser Counter again.l
You are returned to the Config Menu.
USB Scan to Local
This setting allows you to limit or expand the uses for the USB device on the front of the multiple function printer.
If you select On (the default), the contents of the USB device can be viewed or saved on another device, such
as an USB-connected computer. If you select Off, only the MFP can view the USB device contents.
To change the setting:
1. Touch USB Scan to Local from the Config Menu.
2. Touch the left or right arrows to select either Off or On.
3. Touch Submit.
Touch Back to return to the Config Menu screen.
Require Standby See “Require Standby” on page 3-46.
LES Applications See “LES Applications” on page 3-46.
Key Repeat Initial Delay See “Key Repeat Initial Delay” on page 3-46.
Key Repeat Rate See “Key Repeat Rate” on page 3-46.
Clear Custom Status See “Pel Blurring” on page 3-47.
Pel Blurring See “Pel Blurring” on page 3-47.
USB Speed See “USB Speed” on page 3-47.
Exit Config Menu This selection exits Configuration Menu, and then Resetting the
Printer displays. The printer performs a POR and returns to normal
mode.
Reset Fuser Counter
Reset Fuser Counter