3-40 Service Manual
7526
Disable Scanner
If a scanner is not working, the scanner can be disabled, allowing the user to continue using the printer portion of
the multiple function printer. Disable disables the entire scanner (ADF and flatbed), and then users attempting
to use the scanner function receive Scanner disabled by administrator message. ADF Disabled disables
only the ADF, but the flatbed continues to function. Users will receive a Automatic document feeder disabled
by administrator message, and the paper present sensor in the ADF reports empty. Enabled turns the
scanner back on, and is the default setting.
Auto Disabled is not a selection. It appears in response to certain scanner operation failures, and indicates the
scanner is already disabled. Submit is disabled when it appears.
To disable the scanner:
1. Touch Disable Scanner in the Config Menu.
2. Touch the left or right arrows to select Enabled (default), Disabled, or ADF Disabled.
Auto Disabled appears in response to certain scanner operation failures.
3. Touch Submit.
Submitting changes… is displayed.
You are automatically returned to the Configuration main menu.
Automatic Color Adjust
Sets the suggested number of pages which the printer should print between consecutive calibrations.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received
while printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job
in order to perform a calibration. If a user is in any of the menus, including the Configuration Menu and the
Diagnostics mode, an automatic color adjust calibration does not occur.
1. Touch Auto Color Adjust in the Config Menu.
2. Touch the left arrow to decrease the value or the right arrow to increase the value.
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
3. Touch Submit.
Submitting changes… is displayed.
You are automatically returned to the Configuration main menu.
Auto Align Adj
Controls whether the printer executes the automatic alignment calibration after an initiating event occurs. When
an event initiates a TPS operation, the printer performs a toner density calibration, (TPS) an alignment
calibration, or both of the calibrations.
Toner Patch Sensing (TPS) is a diagnostic mechanism that automatically adjusts the printer toner density and
alignment settings. When TPS executes, the printer generates toner patches on the transfer belt. It then uses
these to calculate the appropriate adjustment, to density, if necessary.
To adjust the Auto Align Adj setting:
1. Touch Auto Align Adj in the Config Menu.
2. Touch the left arrow or the right arrow toggle between Off and On (default).
3. Touch Submit.
Submitting changes… is displayed.
You are automatically returned to the Configuration main menu.
To Next Page
Loading...
