Lexmark X734DE - Scanner Tests

Diagnostic aids 3-9
7526
Go Back
Previous
Next
Scanner Tests
ASIC Test
This test initiates a scan of the scanner ASIC memory.
1. Touch SCANNER TESTS in Diag Menu.
2. Touch ASIC Test.
The results will be displayed as either ASIC Test Passed or ASIC Test Failed.
To clear the results, press Stop ().
Feed Test
The feed test scans and feeds continuously from either the ADF or the flatbed, depending on whether or not
paper is placed in the ADF.
1. Touch SCANNER TESTS in Diag Menu.
2. Touch Feed Test.
3. Indicate the specific media size with or , and then touch Start.
• If media is in the ADF, then ADF feed tests are performed.
• If no media is in the ADF or the media is exhausted, then the entire flatbed will be scanned
4. Running… Flatbed:0 ADF:0 displays and the number of successful scans is displayed by incrementing the
number beside the scan type.
If a failure occurs, Feed Test Failed Flatbed:xxxxx ADF:xxxxx. is displayed showing the number of failure
of each scan type.
5. Press Stop ( ) to end the test and clear the messages.
Select a paper size
Letter