Lexmark X734DE - Transfer Module Error Service Check; Engine Software Error, NVRAM MGR Problem

2-106 Service Manual
7526
Go Back
Previous
Next
900.05—Transfer module error service check
902.59—Engine software error, NVRAM MGR problem
31
Contact your next level of support. You will need the following information for them:
• Exact 900.xx error digits and complete error message
• Printed menu settings page
• Printed network settings page
• Device error log
• A sample print file if error appears to be isolated to a single file
• File/Application used if error is related to specific print file
• Device Operating System
• Driver used (PCL/PS)
• Frequency of the occurrence of the error
Step Questions / actions Yes No
1 Turn the printer off, and then remove the rear
frame cover. See “Rear frame cover
removal” on page 4-40.
Check the transport cable in connector JTPS1
for proper connection to the system board,
cable pinch points, and any other damage to
the cable or connector.
Is the cable damaged?
Replace the transport
cable. See “Transport
cable removal” on
page 4-193.
Go to step 2.
2
Replace the transfer module.
Does the error clear?
Problem resolved. Replace the system board.
See “System board
removal” on page 4-165.
Step Questions / actions Yes No
1 Has the system board been recently
replaced?
Replace with a new
printhead that has never
been used before. See
“System board removal”
on page 4-165.
Go to step 2.
2
Has the transfer module been recently
replaced?
Replace with a new
transfer module. See
“Transfer module
removal” on page 4-191.
Go to step 3.
Step Action and questions Yes No
1
JSB1
JBIN1
JFAN1
JFUSER1
JBOR1
JHVPS1
JMIRR1JMIRR1
JBLW1
JCVR1
JLVPS2
JCARTP1
JCARTS1
JCARTS2
JCARTP2
JDVR1
JTPS1
JOPT1
JFDS1
JINT1
JFDPCK1JTRAY1JSEC1
JDX1
JT12
J5
JDIMM1
JOPP1
JT1
JUSB1
JBOOT1
JFMUSB1
J49
JTWF1
JTDBUG1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
JTLBT1
JPH1
F5
F6
F7
F9
F10
F12
F13
F14
1
1
J10
1
1
A