Lexmark X734DE - Duplex Tests

3-18 Service Manual
7526
Go Back
Previous
Next
Duplex Tests
Quick Test (duplex)
Note: Before you set the duplex top margin, be sure to set the skew and alignment. See “Printhead
alignment” on page 4-9.
This test prints a duplex version of the Quick Test that can be used to verify the correct placement of the top
margin on the back side of a duplex page.
You can run one duplexed page (Single), or continue printing duplexed pages (Continuous) until Stop () is
pressed. For information about changing the margin, see “Top Margin (duplex)” on page 3-20.
The paper you choose to print the page on should be either Letter or A4.
To print the Quick Test (duplex):
1. Touch DUPLEX TESTS.
1. Touch Quick Test.
2. Select Single or Continuous.
• The single Duplex Quick test cannot be canceled. It stops when a single duplex sheet is printed.
• The continuous test continues printing until you press Stop ().
• The printer attempts to print the Quick Test Page from the default paper source.
• Check the Quick Test Page for the correct offset between the placement of the first scan line on the
front and back side of a duplexed sheet.