4-32 Service Manual
7526
Operator panel bezel removal
See Operator panel bezel on page 7-3 for the part number.
1. Rotate the operator panel to its highest position.
2. Using a flathead screwdriver or similar tool, unsnap the locking tabs on the upper left and the upper right of
the bezel. The tabs on the right and left side will then release.
3. Rotate the bezel down, and remove the bezel.
Installation note: When reinstalling or replacing the bezel, insert the bottom of the bezel first, ensuring that the
bezel bottom portion fully seats.
To Next Page
Loading...
