Lexmark X734DE - Fax Modem Removal

4-102 Service Manual
7526
Go Back
Previous
Next
12. Connect the motor drive cable connector (S), and make sure the cable is in the cable clamps (T).
13. Reinstall the low-voltage power supply (LVPS).
14. Replace the right and rear covers.
15. Replace the transport belt module and developer units.
16. Replace the cartridges and the fuser.
17. Replace the paper tray.
Fax modem removal
1. Remove the rear frame cover. See “Rear frame cover removal” on page 4-40.
2. Open the left door cover.
3. Loosen the two screws (A) securing the fax modem, and then lift the card to remove it.
4. Disconnect the cable (B) from the connector on the system board. The connector is under the card.
5. Lift, and remove the fax modem.