Lexmark X734DE - Fuser Assembly Removal

4-114 Service Manual
7526
Go Back
Previous
Next
Fuser assembly removal
See “Fuser assembly, 115 V”, “Fuser assembly, 230 V”, or “Fuser assembly, 100 V” on page 7-5 for the
part number.
1. Turn off the printer.
2. Open the top access door.
3. Open the front access door.
4. Rotate the fuser thumbscrews (A) counterclockwise until loosened.
5. Grasp the handles (B), slide the fuser out from the printer.
Installation note: If you install a new fuser, be sure to reset the fuser counter in the Configuration Menu. To
reset the counter:
1. Turn off the multifunction printer, press and hold 2 and 6, turn on the MFP, and release the buttons when
the progress bar displays.
2. Touch Reset Fuser Cnt from the Config Menu.
3. Touch Yes or No.
4. Select Exit Config Menu.
See “Reset Fuser Count” on page 3-31.
CAUTION
The fuser can be extremely hot. Use care when handling to avoid burns.
B
A