3-38 Service Manual
7526
Scanner Manual Registration
This item is used to manually register the flatbed and ADF on the MFP scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually adjust the scanner:
1. Touch Scanner Manual Registration.
2. Touch Print Quick Test.
3. Place the quick test on the glass of the flatbed scanner.
4. Press Copy Quick Test.
5. Select Flatbed.
Examine the copy of the Quick Test and compare it to the original. Adjust the Left Margin and/or the Top
Margin to match the original.
6. Touch Submit.
Submitting changes… is displayed.
7. Place the original printout on the glass of the flatbed, and touch Copy Quick Test.
8. If the pages match, continue to step 9. If the pages do not match, repeat steps 4 through 7, until you are
satisfied.
9. Place the original in the ADF, and touch Copy Quick Test.
10. Examine the copy of the Quick Test and compare it to the original. If it does not match, continue. If it does
match, go to step 11. If it matches go to step 16.
Selection Effect
Left Margin • Decrease the value and move the margin to the left.
• Increase the value and move the margin to the right
Top Margin • Decrease the value to move the margin down
• Increase the value to move the margin upward.
Scanner Manual Registration
Copy Quick Test
Flatbed
ADF Front
ADF Back
Print Quick Test
Flatbed
Top Margin
Left Margin
-7
3
To Next Page
Loading...
