Diagnostic information 2-107
7526
920.03, 920.25—Transfer Module Missing error service check
3
Make sure the printhead is connected to
connector JPH1
Remove the rear frame cover. See “Rear
frame cover removal” on page 4-40.
Is the printhead connected correctly?
Go to step 4. Reseat the connector.
4
Has the printhead been recently replaced? Replace with a new part.
See “Printhead removal,
installation, and
adjustment” on
page 4-147.
Contact the next level of
support.
Step Questions / actions Yes No
1 Open the front access door. Reseat the
transport cable.
Does the error clear?
Problem resolved. Go to step 2.
Step Questions / actions Yes No
To Next Page
Loading...
