Lexmark X734DE - Top Access Cover Assembly Removal

Repair information 4-43
7526
Go Back
Previous
Next
Top access cover assembly removal
See “Top access cover assembly” on page 7-3 for the part number.
Note: If you are planning on installing the top cover assembly to fix the broken top cover spring mount (A), you
can replace just the springs.
See “Top access cover springs removal” on page 4-179 to fasten the springs without having to replace the
entire top cover assembly.
1. Remove the right cover. See “Right cover removal” on page 4-41.
2. Remove the rear frame cover. See “Rear frame cover removal” on page 4-40.
3. Disconnect the operator cable connector at JOPP1 (A) and the USB connector cable in connector
JFMUSB1 (B) on the system board.
4. Remove the USB cable from the cable restraints (C).