Diagnostic information 2-143
7526
5
1. Replace the fuser.
2. Bring the printer up in the Diagnostics
menu (turn off the printer, press and hold
3 and 6, turn on the printer.)
3. Touch SENSOR TESTS.
4. Touch Dynamic Sensors.
5. Touch Bubble.
6. Open the front access door and the top
access cover.
7. Activate the bubble sensor flag (A).
Did the bubble sensor change from Open to
Closed on the touchscreen?
Problem resolved. Replace the system board.
See “System board
removal” on page 4-165.
Step Questions / actions Yes No
To Next Page
Loading...
