3-14 Service Manual
7526
To run the Print Test Page:
1. Touch PRINT TESTS from the Diag Menu.
2. Select the media source by touching the green arrow next to one of the items below:
Tray 1
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multi-Purpose Feeder (if installed)
Print Quality Pages
Only installed trays will appear on the display.
3. Select either Single or Continuous.
• If Single is selected, a single page is printed.
• If Continuous is selected, printing continues until Stop ( ) is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
Note: The Print Test Page always prints on one side of the paper, regardless of the duplex setting.
Print quality test pages (Prt Quality Pgs)
The print quality test consists of five pages. Pages one and two contain a mixture of graphics and text. The
remainder of the pages only contain graphics. The test prints on the media in the default tray.
To Next Page
Loading...
