Diagnostic aids 3-25
7526
Configuration ID
The two configuration IDs are used to communicate information about certain areas of the printer that cannot be
determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is
manufactured. However, the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever the
system board is replaced. The IDs consist of eight digits. The first seven digits in each ID are hexadecimal
numbers, while the last digit is a checksum of the preceding seven digits. Each ID can contain a combination of
the digits 0 through 9, and A through F.
Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs:
• The default standard model Configuration ID is used instead.
• Configuration ID is the only function available in DIAGNOSTICS.
• Unless the menu is in DIAGNOSTICS, Check Config ID displays.
To set the configuration ID:
1. Touch PRINTER SETUP from the Diag Menu.
2. Touch Configuration ID keyboard icon.
The values for Configuration ID 1 and Configuration 2 are displayed.
• Use or to move from one position to another in the Configuration number(s)
• Touch 0 through 9 and/or A through F to input numbers.
• Touch rounded back arrow to erase numbers.
3. Touch Submit.
4. Enter the Configuration ID 1.
• To select a digit or character to change, press or until the digit or character is underlined.
• To change a digit or character, press to increase or to decrease the value.
• When the last digit is changed, touch Submit to validate the Configuration ID 1.
If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the
screen.
If the process is successful, Submitting Selection appears on the display, followed by the current
value for Configuration ID 2.
5. Repeat the steps for entering the Configuration ID, and then touch Submit.
If the Configuration ID 2 is validated, Submitting Selection appears, and then a check ( ) appears next
to Printer Setup.
Note: The printer will NOT perform an automatic POR after the Configuration IDs are accepted.
Exit
Diag Menu
PRINTER SETUP
Reset Color Cal
Motor Calibration
Configuration ID
ID1: XX XX XX XX -ID2: XX XX XX XX
To Next Page
Loading...
