Lexmark X734DE - Page 257

Diagnostic aids 3-61
7526
Go Back
Previous
Next
3. Pull the jammed paper up and out to remove it from behind the toner cartridge area.
Note: Make sure all paper fragments are removed.
4. Close the lower front door.
5. Close the upper front door.
6. Touch Continue.
200–201 paper jams
1.
Open the upper front door.
2. Open the lower front door.
Note: To avoid overexposing the photoconductor units, do not leave the front door open longer than
10 minutes.
3. Pull the paper forward if it is lodged under the photoconductor units.
Note: You may need to remove the photoconductor units if the paper is lodged too tightly under them.
4. Remove each photoconductor unit, and then place it on a flat surface. See “Photoconductor unit
removal” on page 4-144.
5. Remove the jammed paper, and then replace each photoconductor unit.
6. Close the lower front door.
7. Close the upper front door.
8. Touch Continue.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching.