3-64 Service Manual
7526
Paper jam behind the fuser
1. Open the upper front door, and then open the lower front door.
Warning: Potential Damage—To avoid overexposing the photoconductors, do not leave the front doors
open for more than 10 minutes.
2. If the paper is jammed behind the fuser, then remove the fuser:
a. Turn the screws on the fuser to the left.
b. Lift the fuser, and then pull forward to remove it.
c. Place the fuser on a flat surface.
3. Pull the paper gently out of the printer or up toward the standard exit bin to remove it.
4. Reinstall the fuser:
a. Align the fuser, and then place it back into the printer.
b. Turn the screws to the right to fasten the fuser securely.
5. Close the lower front door, and then close the upper front door.
6. Touch Continue.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching.
To Next Page
Loading...
