Repair information 4-181
7526
4. Rotate the pivot (A) upward.
5. Slide the pivot out of the frame and outer top access cover holes. Do not remove it from the inner hole. If a
spring is attached to the pivot, remove it.
6. Place the new spring in place to hook onto the pivot, and push the pivot back into place securing the spring
on the pivot.
If the original rib where the spring was attached is broken off (B) or is no longer there (newer parts), make
sure the spring is oriented so the spring bend is on the bottom (C). If the original rib is present (D), orient
the spring to go through the gap in the rib, with the bend at the top (E).
To Next Page
Loading...
