Repair information 4-189
7526
2. Rotate the camshaft up using the camshaft actuator handle (C), and make sure the gears on the right side
mesh so the first gear tooth of the camshaft aligns with the first two gear teeth of the EP drive actuator
rack (D).
Note: Make sure the actuator rack on the EP drive is all the way back.
3. Flex the EP drive on the right to seat the end of the shaft into the boss (E) on the EP drive.
4. Rotate the camshaft up using the camshaft actuator handle (F) so you can access the other two screws
(G), and remove them.
To Next Page
Loading...
