Lexmark X734DE - Page 49

Diagnostic information 2-11
7526
Go Back
Previous
Next
37 Insufficient memory
to collate job
•Touch Continue to print the portion of the job already stored and begin collating the rest
of the job.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
37 Insufficient memory
for Flash Memory
Defragment operation
•Touch Continue to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace the system. See “System board removal” on
page 4-165.
37 Insufficient memory,
Some Held Jobs Were
Not Restored
• The printer deleted some held jobs in order to process current jobs.
•Touch Continue to clear the message.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
37 Insufficient memory,
Some Held Jobs Will
Not Be Restored
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
•Touch Continue to clear the message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
37 Insufficient Defrag
Memory
New
There is insufficient memory to perform the Flash Memory Defragment operation. The user
can:
• Delete font, macros, and other data in memory.
• Install additional printer memory.
38 Memory Full The following options are available:
•Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
39 Complex Page The page is too complex to print. Options are:
•Touch Continue to continue. The job may not print correctly.
• Cancel the job.
50 PPDS Font Error • Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
51 Defective Flash • Touch Continue to clear the message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
52 Flash Full • Touch Continue to clear the message and continue printing.
Note: Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-165.
Error code Action