Diagnostic information 2-15
7526
82 Replace Waste
Toner
• Replace the waste toner box using the instruction sheet that comes with the replacement
waste toner box.
• Ensure that there is no interference between the waste toner box and the printer.
• If the problem persists, open the front access door and check the aligner shaft for binding.
Clear the binding if possible.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
• If the problem persists, contact your next level of service.
82 Waste Toner Missing • Insert the waste toner box.
• Inspect the top cover camshaft assembly for proper operation. When the top access
cover is closed, the printer should mechanically interlock.
• Check the cable on the system board for defects and proper connection. If the cable
wiring or the cable connection is defective, replace the aligner motor. See “Multipurpose
feeder (MPF)/duplex motor assembly removal” on page 4-130. If the cable is
damaged on the system board, replace the system board. See “System board removal”
on page 4-165.
• Check the aligner shaft and the mechanical system for binds.
• Replace the aligner motor. See “Multipurpose feeder (MPF)/duplex motor assembly
removal” on page 4-130.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
82.41 Aligner motor error. Go to “147.xx, 920.01—Motor (aligner) error service check” on
page 2-55.
83.xx Transfer Module
Life Warning
•Touch Continue to clear the message and continue printing.
• Order a replacement transfer module. When print quality is reduced, install the new
transfer module using the instruction sheet that comes with the replacement transfer
module.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
83 Replace Transfer
Module
• Replace the transfer module using the instruction sheet that comes with the replacement
transfer module. See “Transfer module removal” on page 4-191.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
83.41 Transfer Module
Missing
If you continuously get this error, then check the transfer module. Go to “920.03, 920.25—
Transfer Module Missing error service check” on page 2-107.
84 <color> PC Unit Life
Warning
•Touch Ignore to clear the message and continue printing.
• Order the specified photoconductor unit. When print quality is reduced, install the new
specified photoconductor unit using the instruction sheet that comes with the replacement
specified photoconductor unit.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
84 Replace <color> PC
Unit
• Replace the specified photoconductor unit using the instruction sheet that comes with the
replacement specified photoconductor unit.
• If the problem persists, replace the system board. See “System board removal” on
page 4-165.
Error code Action
To Next Page
Loading...
