Repair information 4-285
7526
5. Remove the screw (C) securing the cable tie-down, and remove the cable from the tie-down.
6. Remove the cable from the cable restraints (D), and note the routing.
7. Open the clips (E) on the toroid, and set it aside for reinstallation later.
8. Turn the ADF over.
9. Remove the ADF motor side cover. See “ADF motor side cover removal” on page 4-232.
10.Remove the screw (F) and disconnect the scanner ICC cable ground cable (G).
11.Remove the scanner ICC cable.
To Next Page
Loading...
