Connector locations 5-11
7526
JTPS1
Toner Patch Sensor
1 V12_LED_ON 2 VS12_3_3V
3 GD_TPS_SNS 4 GD_TPS_PWM1
5 GD_TPS_SNS_RTN 6 GD_TPS_TNR_SNS
7Ground 8 I2C_CLK_TB
9 I2C_DATA_TB 10 GD_TPS_THERM_SNS
JTRAY1
Tray 1 input, NMT sensors
1Ground
2 S_TRAY_INPUT
3 VS12_TRAY_INPT_LED
4 VS12_TRAY+5V_NMT
5 S_TRAY_NMT
6Ground
JTWF1
Winflex serial port (engine)
1Ground
2 TG_RXD1
3TG_TXD1
4 +5 V dc or Ground
JUSB1
USB device port
1 USB_DEV_VBUS_R
2 USB_DEVD-
3 USB_DEVD+
4Ground
G1 Ground
G2 Ground
JUSB2
Back USB port
1+5 V dc
2 USB_DM3
3 USB_DP3
4NC
5Ground
System board listing (continued)
See “System board” on page 5-2.
Connector Pin # Signal Pin # Signal
To Next Page
Loading...
