Lexmark X734DE - Page 74

2-36 Service Manual
7526
Go Back
Previous
Next
920.07
POST Error
Narrow media sensor not connected. • POR the printer.
• If the error message persists, go to “920.07—
POST error service check” on page 2-111.
920.08
POST Error
Exit sensor not connected. • POR the printer.
• If the error message persists, go to “Exit
sensor service check” on page 2-145.
920.09
POST Error
Four toner sensors are not connected. • POR the printer.
• If the error message persists, go to “920.09—
POST—Four toner sensor not connected
error service check” on page 2-112.
920.10
POST Error
Three toner sensors are not
connected.
• POR the printer.
• If the error message persists, go to “920.10—
POST—Three toner sensors not connected
error service check” on page 2-113.
920.11
POST Error
Two toner sensors are not connected. • POR the printer.
• If the error message persists, go to “920.11—
POST—Two toner sensors not connected
error service check” on page 2-114.
920.12
POST Error
One toner sensor is not connected. • POR the printer.
• If the error message persists, go to “920.12—
POST—One sensor not connected error
service check” on page 2-115.
920.13
POST Error
Cartridge motor 1 (top) not connected. • POR the printer.
• If the error message persists, go to “920.13—
POST error service check” on page 2-115.
920.14
POST Error
Cartridge motor 2 (middle) is not
connected.
• POR the printer.
• If the error message persists, go to “920.14—
POST—Cartridge motor 2 not connected
error service check” on page 2-117.
920.15
POST Error
Bad transfer module NVRAM data. • POR the printer.
• If the error message persists, go to “920.15,
920.20—POST—Bad transfer module
NVRAM data error service check” on
page 2-118.
920.16
POST Error
Bad printhead NVRAM data. • POR the printer.
• If the error message persists, go to “920.16—
POST error service check” on page 2-119.
920.17
POST Error
Output bin cable not connected. • POR the printer.
• If the error message persists, go to “920.17—
POST error service check” on page 2-120.
920.18
POST Error
Cartridge motor 3 (bottom) is not
connected.
• POR the printer.
• If the error message persists, go to “920.18—
POST—Cartridge motor 3 not connected
error service check” on page 2-121.
920.19
POST Error
Stepper motor not connected. • POR the printer.
• If the error message persists, go to “920.19—
POST—Transfer module stepper motor not
connected error service check” on
page 2-122.
Error code Description Action