LogTag TRIX-8/TRIX-16 Work Instruction Manual Revision 9.20 Page 40/53
Customisation (cont)
Display will then display the ‘waiting for LogTag’ screen detailing the labels to attached.
An example is shown below :-
5. Insert LogTag just scanned into interface
6. Repeat steps 2-5 for all the LogTags for the batch (or until the software prompts for a new batch ID).
This means the all the LogTags for the order have been completed.
NOTE
1. The customisation software can be closed midway and re-opened later and will keep track of the
number of products remaining for a given customer order.
2. DO NOT have the customisation software running on two computers at the same time with the same
batch ID.
3. DO NOT change to a different computer during a given batch is being processed.
4. Note that the bottom of the window shows the number processed and the current subcarton being
loaded (A,B,C or D).
To Next Page
Loading...
