53
Appendix B: Setting up Local and Remote Viewing
5. Type ipconfig and press Enter. Your network information appears (see figure 24.1). You may
need to enter some of this information in your system’s LAN settings.
6. On the system, click
to open the Main Menu. Click LAN.
• If the IP address and Gateway are the SAME as those in ipconfig on your PC, your system
is connected to your local network.
• If the IP address and Gateway are DIFFERENT than those in ipc
onfig on your PC, go to
step 5.
7. Under IP, select the third field (001) and enter the third set of numbers from the IP address
in the Command
Prompt window. Under Gateway, select the third field (001) and enter the
third set of numbers from the Default Gateway in the Command Prompt window Right-click
to exit all menus to save your settings (or press the ESC button on the remote control).
Figure 24.1 IP configuration information
Enter the third set of numbers from
the IP address and Gateway in the LAN
settings of your system.
In this example, the number is
11
.
Figure 24.2 Default IP address and Gateway
Figure 24.3 New IP address and Gateway
NOTE: The third set of numbers in
IP and Gateway in your LAN settings
MUST MATCH the third set of
numbers in IP address and Default
Gateway from the IP Config results in
the Command Prompt window. You do
not need to change any of the other
sets of numbers.
NOTE: In this example, we changed
the default digit from
001 to 011
in
order to match the IP address and
Default Gateway in ipconfig.
To Next Page
Loading...
Need help?
General