LOYTEC L-IP User Manual

L-IP User Manual 127 LOYTEC
Version 6.1 LOYTEC electronics GmbH
router is less then <Warning Limit> % of the number of packets forwarded by the twin
router an warning is triggered.
Min Messages
This value defines minimum number of packets to be forwarded on the twin router to issue a
“Forwarding Error” (see nvoTwinStatus, Section 9.7.4 or alarm log, Section 9.6.3): If the
number of packets forwarded by the local router is zero but the number of packets
forwarded by the twin router is at least < Min Messages > the alarm is issued. Further, if the
device is the primary router the secondary router will take over (standby mode).
Enable Node Monitor
Deselecting this check box will disable node monitoring (see 9.2.3).
Max Send Time
This parameter influences the heart beat functionality in the device monitor object of the
diagnostic node. If set to 0 the heart beat functionality is disabled, any other value will
enable heart beat functionality and nvoNodeMonAlarm, nvoNodeMonStatus,
nvoRingALastNode, nvoRingBLastNode, nvoRingAReceived and nvoRingAReceived will be
sent out with the interval defined by this value.
Min Monitor Send Time
This value defines the interval used to send query status messages to the nodes in the node
list. Thus, the maximum delay until a node failure is detected and the duration of a complete
scan pass calculates to:
eListNodesInNodSendTimeMinMonitorimeTotalScanTonDelayMaxDetecti 
Channel Monitor Interval
This value defines the interval which is used by the channel monitor objects to accumulate
statistic data and to calculate the resulting average values.
CEA-709 Ch. Monitor/CEA-852 Ch. Monitor
Deselecting these check boxes will disable the corresponding channel monitor object (see
Section 9.2.3).
Bandwidth Utilization Limit
This value defines the upper bandwidth utilization limit for the calculation of the overload
condition. If the current bandwidth utilization exceeds this limit the corresponding channel
is considered to be in overload state. Set this value to 0 to exclude the bandwidth utilization
from the calculation of the overload state.
CRC Error Limit
This value defines the upper CRC error rate limit for the calculation of the overload
condition. If the current CRC error rate exceeds this limit the corresponding channel is
considered to be in overload state. Set this value to 0 to exclude the CRC error rate from the
calculation of the overload state.
Missed Preamble Limit
This value defines the upper missed preamble rate limit for the calculation of the overload
condition. If the current missed preamble rate exceeds this limit the corresponding channel

LOYTEC L-IP Specifications

General

Brand	LOYTEC
Model	L-IP
Category	Network Router
Language	English