L-IP User Manual 18 LOYTEC
Version 6.1 LOYTEC electronics GmbH
3 Quick-Start Guide
This Chapter shows step-by-step instructions on how to configure the L-IP for a simple
network architecture in a LAN environment.
3.1 Hardware Installation
3.1.1 L-IP
Connect power 12-35 VDC or 12-24 VAC, the CEA-709 network, and the Ethernet cable as
shown in the installation sheet. More detailed instructions are shown in Chapter 4.
3.1.2 L-IP Redundant
Connect power 12-35 VDC or 12-24 VAC, the Ethernet cable and the CEA-709 network
the installation sheet. Depending on the desired redundancy mode choose one of the cabling
topologies as shown in Figure 4 to Figure 6. More detailed instructions are shown in
Chapter 4.
To Next Page
Loading...