Name: LOYTEC L-IP
Brand: LOYTEC
Rating: 5 (1 reviews)

To Next Page

To Previous Page

L-IP User Manual 41 LOYTEC

Version 6.1 LOYTEC electronics GmbH

9 - Bit-rate auto-detection configuration source (only if RS-485 port is present)

This menu item allows to set what decision element should be used to enable or disable the

bit-rate auto-detection. If [1] DIP Switch is selected the value set on the DIP switch (refer to

the installation sheet of the product) is used to enable or disable the bit-rate auto-detection.

If [2] Manual is selected the setting made with Option 1 – 5 is used to enable or disable the

bit-rate auto-detection.

r - Router configuration

This menu item opens the CEA-709 router configuration menu as described in Section

5.5.2.

5.5.2 CEA-709 Router Configuration Menu

This menu allows configuring the CEA-709 router mode.

CEA-709 Router/Switch Menu

==========================

[1] Router mode : Smart Switch

[2] Subnet/node learning : subnet/node

[3] Group learning : enabled

[5] Block unknown domains : disabled

[6] Switch reset w. status button : enabled

[q] Quit without saving

[x] Exit and save

Please choose:

Figure 30 CEA-709 router configuration menu.

1 - Router Mode

The router mode menu allows setting the principal operating mode of the L-IP routing core.

Normally the operating mode of the routing core is set with the DIP switches 1 and 2 but

can be overridden in this menu.

Set router mode

===============

[1] Enable Configured Router Mode

[2] Enable Smart Switch Mode

[3] Set router configuration according to DIP switch

Please choose:

Figure 31 Router mode configuration menu

2 - Subnet/node learning

This menu option allows selecting the subnet/node learning mode (see Figure 32).

Set subnet/node learning mode

=============================

[1] Subnet/node learning

[2] Subnet learning

[3] Disable

[4] Set router configuration according to DIP switch

Please choose:

Figure 32 Selecting subnet/node learning mode

If subnet/node learning is selected the L-IP will learn based on subnet/node addresses (see

Section 7.1.2). Subnet broadcasts are flooded. This mode is plug&play.

If subnet learning is selected the L-IP will learn based on subnets. Subnet broadcasts are

only forwarded to ports, which contain nodes with that subnet. Subnet learning should be

Brand	LOYTEC
Model	L-IP
Category	Network Router
Language	English

LOYTEC L-IP User Manual

Table of Contents

Questions and Answers:

LOYTEC L-IP Specifications