L-IP User Manual 28 LOYTEC
Version 6.1 LOYTEC electronics GmbH
4.3 Mounting
The device comes prepared for mounting on DIN rails following DIN EN 50 022. The
device can be mounted in any position. However, an installation place with proper airflow
must be selected to ensure that the L-IP temperature does not exceed the specified range.
4.4 LED signals
Available LEDs and their location on the respective device model can be found on the
product’s installation sheet. The installation sheet can be found in the product’s box.
4.4.1 Power LED
The power LED lights up green when power is supplied to the power terminals.
4.4.2 Status LED
The L-IP is equipped with a red status LED (see installation sheet). This LED is normally
off. If the fall-back image is executed the status LED flashes red once every second.
4.4.3 CEA-709 Activity LED
The CEA-709 port on the L-IP has a three color LED (green, red and orange, see
installation sheet). Table 2 shows different LED patterns of the port and their meaning.
Table 2: CEA-709 Activity LED patterns.
4.4.4 Twin Router Status LED (L-IP Redundant only)
The L-IP Redundant has a three color LED (green, red and orange, see installation sheet)
showing the twin router status of the device. This LED is labeled “PRIM”. Table 3 shows
different LED patterns and their meaning.