L-IP User Manual 109 LOYTEC
Version 6.1 LOYTEC electronics GmbH
The router in the L-IP Redundant can only be used as Configured Router and thus requires
to be commissioned with a network management tool (e.g. LonMaker) like any other router.
Smart Switch Mode, Repeater Mode and Bridge Mode are not supported.
Since the diagnostic node resides on the CEA-709 side of the router, the router must be
commissioned before the diagnostic node. To configure the diagnostic node with an LNS
based network management tool, LOYTEC provides the “L-IP Redundant Plug-In” (see
Section 9.5).
9.4 Installation
9.4.1 Installing the L-IP Redundant Plug-In
The L-IP Redundant Plug-In is used to configure the L-IP Redundant node monitoring (see
Section 9.2.3), configure the various parameters influencing the behavior of the L-IP
Redundant, download the L-IP Redundant Alarm Log, and view the current state of the L-IP
Redundant. This configuration utility is installed as a plug-in tool for all LNS based network
management tools.
System requirements:
LNS 3, Service Pack 7 or higher
Windows XP, Windows Vista or Windows 7.
The L-IP Redundant Plug-In can be downloaded from the LOYTEC website
http://www.loytec.com. To install the configuration utility double click on Setup and follow
the installation steps.
Figure 101: Be sure to be logged in as Administrator on Windows 2000/XP.
To Next Page
Loading...