LOYTEC L-IP User Manual

L-IP User Manual 102 LOYTEC
Version 6.1 LOYTEC electronics GmbH
Figure 95: Drag the L-IP (Router) shape onto the drawing area and commission the device.
8. Now drag the L-IP (Router) shape from the “LoytecShapes” stencil onto the
drawing area. Choose the existing channel “IP Channel” for the first router port
and the existing channel “Channel 1” for the second port. Finally you must
commission the new L-IP router. LonMaker can now use the L-IP as a local or
remote network interface that connects directly to the Ethernet network as shown
in Figure 95.
8.5 Remote LPA Operation
The L-IP supports remote LPA access. This means that a CEA-709 protocol analyzer
connected to the Ethernet network can connect to the L-IP and record all packets on the
CEA-709 channel (FT-10). Our LPA-IP supports this sophisticated feature. The
functionality is shown in Figure 96.
The LPA-IP runs on a Windows PC that is connected to the Ethernet network. In a device
selection window, one can e.g. select the L-IP with IP address 192.168.1.210 and display all
packets on the FT-10 channel connected to the L-IP with IP address 192.168.1.210. For this
operation, the LPA-IP does not need to be a member of the IP-852 channel. Note that this
functionality is only available with LOYTEC CEA-852 devices.

LOYTEC L-IP Specifications

General

Brand	LOYTEC
Model	L-IP
Category	Network Router
Language	English