LSIS sv-ig5a User Manual

8-31
8.25 Parameter Initialize / Lock
 Parameter initialize
Group
Display
Parameter Name
Range
Default
Function
group 2
H93
[Parameter initialize]
0
-
0
1
4 groups initialize
2
Drive group initialize
3
F 1 group initialize
4
F 2 group initialize
5
I/O group initialize
 Select the group to be initialized and perform it in H93 code.
 Press Enter () key after setting in H93. H93 will be displayed again after initialization is
complete.
 Password register
Group
Display
Parameter Name
Setting
Range
Default
Unit
Function
group 2
H94
[Password register]
-
0 ~ FFFF
0
H95
[Parameter lock]
-
0 ~ FFFF
0
 Register password for Parameter lock (H95).
 Password should be Hex decimal. (0 ~ 9, A, B, C, D, E, F)
CAUTION
After setting modification lock function of H95, Do not forget the registered
password. if you try to release lock, you need the registered password.
 Factory default password is 0. Enter the new password except 0.
 Follow the steps below when you register the password for the first time.
Step
Note
Keypad display
1
Move to H94 code.
H94
2
Press Enter () key twice.
0
3
Register password. (Ex: 123)
123
4
123 will blink when Enter () key is pressed.
123
5
Press Enter () key.
H94
For Service Call 800-848-2504
For Service Call 800-848-2504

LSIS sv-ig5a Specifications

General

Brand	LSIS
Model	sv-ig5a
Category	Inverter
Language	English