LSIS sv-ig5a User Manual

4-10
4.5 Parameter setting
 Changing parameter values in Drive Group
When changing ACC time from 5.0 sec to 16.0 sec
Drive group
1
-. In the first code “0.00”, press the Up () key once to go to the second
code.
2
-. ACC [Accel time] is displayed.
-. Press the Ent key () once.
3
-. Preset value is 5.0, and the cursor is in the digit 0.
-. Press the Left () key once to move the cursor to the left.
4
-. The digit 5 in 5.0 is active. Then press the Up () key once.
5
-. The value is increased to 6.0
-. Press the Left () key to move the cursor to the left.
6
-. 0.60 is displayed. The first 0 in 0.60 is active.
-. Press the Up () key once.
7
-. 16.0 is set.
-. Press the Ent () key once.
-. 16.0 is blinking.
-. Press the Ent () key once again to return to the parameter name.
8
-. ACC is displayed. Accel time is changed from 5.0 to 16.0 sec.
♣ In step 7, pressing the Left () or Right () key while 16.0 is blinking will disable the
setting.
Note 1) Pressing the Left ()/ Right () /Up () /Down () key while cursor is blinking will cancel
the parameter value change. Pressing the Enter key () in this status will enter the value into
memory.
For Service Call 800-848-2504
For Service Call 800-848-2504

LSIS sv-ig5a Specifications

General

Brand	LSIS
Model	sv-ig5a
Category	Inverter
Language	English