LSIS sv-ig5a User Manual

9-4
9.3 Monitoring fault condition
 Monitoring current fault status
Group
Display
Parameter Name
Setting
Range
Default
Unit
Drive group
nOn
[Current Fault Display]
-
 Fault occurred during operation is displayed in nOn.
 Up to 3 kinds of faults can be monitored.
 This parameter gives information on fault types and the operating status at the time of the fault.
Refer to Page 4-11 or 9-5 for keypad setting.
Fault
types
Frequency
Current
Accel/Decel
Information
Fault during Accel
Fault during Decel
Fault during constant run
 Refer to Page 12-1 on fault types.
 Fault History Monitoring
Group
Display
Parameter Name
Setting
Range
Default
Unit
Function
group 2
H 1
[Fault history 1]
-
~
~
H 5
[Fault history 5]
H 6
[Reset fault history]
-
0 ~ 1
0
 H 1 ~ H 5: Up to 5 faults information is stored.
 H 6: Previous fault information stored in the code H1 thru H5 is all cleared.
 When a fault occurs during operation, it can be monitored in the nOn.
For Service Call 800-848-2504
For Service Call 800-848-2504

LSIS sv-ig5a Specifications

General

Brand	LSIS
Model	sv-ig5a
Category	Inverter
Language	English