LSIS sv-ig5a User Manual

4-6
4.3 Moving to other groups
 There are 4 different parameter groups in SV- iG5A series as shown below.
Drive group
Basic parameters necessary for the inverter to run. Parameters
such as Target frequency, Accel/Decel time settable.
Function group 1
Basic function parameters to adjust output frequency and
voltage.
Function group 2
Advanced function parameters to set parameters for such as
PID Operation and second motor operation.
I/O (Input/Output)
group
Parameters necessary to make up a sequence using Multi-
function input/output terminal.
 Moving to other parameter groups is only available in the first code of each group as the
figure shown below.
Moving to other groups using the Right ()
key
Moving to other groups using the Left () key
Function
group 1
Function
group 2
I/O group
Drive group
*
Function
group 1
Function
group 2
I/O group
Drive group
*
* Target frequency can be set at 0.0 (the 1
st
code of drive group). Even though the preset value is 0.0, it is
user-settable. The changed frequency will be displayed after it is changed.
I/O group
FU group 2
FU group 1
Drive group
For Service Call 800-848-2504
For Service Call 800-848-2504

LSIS sv-ig5a Specifications

General

Brand	LSIS
Model	sv-ig5a
Category	Inverter
Language	English