Where: 2 = MHD number to be restored
Response: RST MHD 2 TASK y MSG STARTED
RST MHD 2 IN PROGRESS
RST MHD 2 COMPLETED
7. The AMA partitions must now be cleaned up. Initialize AMA Disk Writer. Type
and enter:
INIT:AM,AMDW1,FPI;
Response: REPT AMA DISK WRITER FOR STREAM ST1
RECORDING TO DISK SUSPENDED
REPT AMA DISK WRITER FOR STREAM ST1
TERMINATION CODE 2
REPT AMA DISK WRITER FOR STREAM ST1
ERROR CODE 6
REPT AMA DISK WRITER FOR STREAM ST1
INITIALIZATION COMPLETE
REPT AMA DISK WRITER FOR STREAM ST1
RECORDING TO DISK RESUMED
8. Verify software update levels of AM text (/no5text) and switching modulet
(/no5text/im). Type and enter:
OP:VERSION;
OP VERSION mm dd, yyyy
PARTITION VERSION BWM
ECD 5ex(x)xx.xx
/ 5ex(x)xx.xx BWMnn-nnnn
/etc 5ex(x)xx.xx BWMnn-nnnn
/unixa 5ex(x)xx.xx BWMnn-nnnn
/no5text/im 5ex(x)xx.xx BWMnn-nnnn
/no5text 5ex(x)xx.xx BWMnn-nnnn
9. Are the software update levels of /no5text and /no5text/im the same?
If YES, continue with the next step.
If NO, go to “Restore Switching Module Text on Outboard MHDs,” Subprocedure
7.2.2, to recover switching module text, then return to the next step.
10. ALL disks containing switching module ODD must be recovered from tape if any
of the following conditions exist:
• AM ODD recovered on an MHD restored from AM ODD backup tapes,
• Any outboard MHD containing switching module ODD was duplexed failed so
that the switching module ODD on that disk is known to be bad.
Do any of these conditions exist?
If YES, go to “Restore the Switching Module ODD,” Subprocedure 7.2.3, to
recover switching module ODD, then return to the next step.
If NO, continue with the next step.
SYSTEM RECOVERY
Procedure 7.2.1
235-200-150
January 2003
Page 7.2.1-2 Issue 3.00
To Next Page
Loading...