(a) Type and enter: ttyadd
Response: ttyadd form displayed. Cursor at 1.tty_name:
Note: An ! may be entered any time prompted to abort the form and
return to the state when the form was started.
(b) Type and enter the following data:
1. tty_name
a
: enter TTY7
2. baud_rate: enter (as specified or CARRIAGE RETURN)
3. login_term: enter (as specified or CARRIAGE RETURN)
4. auth_chk: enter (as specified or CARRIAGE RETURN)
5. term_type: enter (as specified or CARRIAGE RETURN)
6. line_mode: enter (as specified or CARRIAGE RETURN)
7. port: enter 2 or 3 for TTYC port (see Table 8.3-1 and
8.3-2)
8. ttyc_number: enter TTYC number base on SAI port (see Table
8.3-1 and 8.3-2)
9. plu_unit_name: enter CARRIAGE RETURN
10. plu_unit_number: enter CARRIAGE RETURN
Note(s):
a. tty_name must be entered in all capital letters.
Note: Fields not specified receive the default value by entering
CARRIAGE RETURN.
Note: When growing a TTY terminal a defensive check failure message
REPT CONFIG FAULT Assert = 412 may be received. This failure message
may be ignored.
4. Install the traffic printer to the SAI port corresponding to the TTYC port and
TTYC number chosen in Tables 8.3-1 and 8.3-2 (see Figures 8.13-1 , 8.13-2 and
8.13-3).
(a) Enter CARRIAGE RETURN
2. Trademark of Sun Microsystems, Inc.
GROWTH AND DEGROWTH
Procedure 8.13
235-200-150
October 2005
Page 8.13-2 Issue 3.01
To Next Page
Loading...
Need help?
General