MacDon D50 - Installing Beater Bars

169441 93 Revision D
1001653
A
B
C
Figure 3.89: Beater Bars
3. Remove bolts (A) securing beater bars (B) and clamps (C) to
the auger tubes, and remove the beater bars and clamps.
1001652
A
B
C
Figure 3.90: Beater Bars
3.20.2 Installing Beater Bars
Beater bars can improve the delivery of material through the header opening.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
NOTE:
Some newer upper cross augers do not have beater bars.
1. Lower the header to the ground.
2. Shut down the engine, and remove the key from the ignition.
OPERATION