MacDon M205 2010 - Page 47

OPERATOR’S STATION
Form 169469/169470/169471 45 Revision C
DISPLAY WARNINGS AND ALARMS (Continued)
DISPLAY
FLASHING
ALARM TONE DESCRIPTION
### °C or F HYD OIL COLD

Tone Sounds With Each Flash For
5 Seconds and Then Stops For 1
Minute. Flashing Continues. If Oil
Still Cold After 1 Minute, Tone
Sounds Again.
Hydraulic Oil Temp <10C or 50F.
### °C or F HYD OIL HOT

Tone With Each Flash At 105C
(220F) For 5 Seconds and Then
Stops For 1 Minute. Flashing
Continues. If Oil Still Hot After 1
Minute, Tone Sounds Again.
Flashing & Steady Tone At 110C
(230F) and Higher.
Hydraulic Oil Temp >105C (220F)
but <110C (230F).
IN PARK

One Short Beep.
GSL In N-Detent, Steering Wheel
Centered, and Brakes Are Engaged.
KNIFE SPEED OVERLOAD

Short Beep With Each Flash Until
Condition Is Corrected.
Machine Overload. Knife or Disc
Speed Drops Below Programmed
Value.
LOCK SEAT BASE
Seat Base Not Detected In Cab or
Engine-forward Position.
LOW HYDRAULIC OIL

Continuous Loud Tone For 5
Seconds. If Condition Not
Rectified, Single Loud Tone Every
5 Minutes.
Low Hydraulic Oil Level. Header
Shuts Down Automatically If
Engaged. Header On Switch Must
Be Moved To OFF Position and
Then To ON Position To Restart The
Header.
NO HEADER
None Header Is Not Detected.
NO OPERATOR
Continuous Tone.
Operator Not Detected In Seat With
Header Engaged or Out Of Neutral
Detent. Engine Shutdown After 5
Seconds.
NO OPERATOR
ENGINE SHUTDOWN
Continuous Tone.
Engine Shutdown When Operator
Not Detected In Seat With Machine
Moving Under 3 mph (4.8 km/h).
NOT IN PARK

Short Beep With Each Flash.
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
PLACE GSL INTO “N”
Beeps At 2 Per Second Until
Corrected.
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
SLOW DOWN

Short Beep With Each Flash.
Ground Speed is Greater Than or
Equal to 25 mph (40 km/h).
Operator Should Pull Back on the
GSL to Reduce Ground Speed.
TRANS OIL PRESS

Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Transmission Charge Oil
Pressure.
TRANS OIL TEMP

Ongoing Intermittent Moderate
Tone Until Temperature Is Below
Acceptable Level.
Transmission Oil Temperature
Above 221F (106C).
##.# LOW VOLTS

Single Loud Tone For 10 Seconds.
Voltage Below 11.5.
##.# HIGH VOLTS

Single Loud Tone For 10 Seconds.
Voltage Above 16.