.
If an actuator has been selected, the Actuator dialogue shown below ap
-
pears. Select an actuator from those listed. A set of parameters for the actua
-
tor appears; set these up according to the manufacturer’s documentation.
If using a Spraytec Nasal Spray Support (NSS), select the Uses Spraytec
NSS check box and specify its setup; the online help gives full details. The
Spraytec Accessories manual describes the NSS.
Select the Reset reference position on repeat check box if intending to
run the SOP multiple times (by clicking OK after a run when asked
whether to repeat the measurement). In this case the settings specified the
first time will automatically be used for each run without any need to
reposition the spray. Click Next.
.
If extraction has been selected the Extraction dialogue appears:
CHAPTER 5
Spraytec
Page 5.14 MAN 0368
To Next Page
Loading...
