Manitowoc Grove CD3340B - Page 232

AXLES/DRIVE SHAFTS/WHEELS AND TIRES CD3340B/YB4411
8-16
Published 04/07/2015 Control # 569-00
17. Remove the Belleville washers and shim from the upper
and lower side of the axle beam (Figure 8-54).
18. Place the swivel housing on a flat surface and pry out
the oil seal ring (Figure 8-55). The seal ring will be
damaged during this procedure.
19. Turn the swivel housing over and using the SPECIAL
TOOL P/N 1901766 and hammer remove the bushing
(Figure 8-56).
20. Using a suitable puller, remove the bushings from the
king pins (Figure 8-57).
Axle Beam and Brake Disassembly
1. Pry the seal ring (A, Figure 8-58) from the axle beam.
The seal ring will be damaged during the removal
procedure. Using a chisel and hammer, remove bushing
(B) from the axle beam. Using a suitable puller, remove
bushings (C) from the king pin housings.
P0602
FIGURE 8-53
P0603
FIGURE 8-54
P0604
FIGURE 8-55
P0605
FIGURE 8-56
A0696
FIGURE 8-57
A0697
FIGURE 8-58
Reference Only