Manitowoc Grove CD3340B - Page 233

GROVE 8-17
CD3340B/YB4411 AXLES/DRIVE SHAFTS/WHEELS AND TIRES
8
Published 04/07/2015 Control # 569-00
2. Put alignment marks on the axle beam and on the
differential supporting flanges (Figure 8-59) to identify
the right and left sides during assembly.
3. Place the axle on supports. The center housing and two
axle beams must have their own supports, which must
support each component during disassembly. If supports
are not available, use a hoist and sling to support each
part separately (Figure 8-60).
4. Unscrew the screws securing the axle beam to the
center housing (Figure 8-61).
5. Remove the axle beam (Figure 8-62). When removing
the axle beam be careful that the brake discs do not fall
from the brake flange. Remove the O-ring from the axle
beam.
6. Remove brake counter disc (B, Figure 8-63). Remove
retaining ring (A). Remove brake disc (C). Remove
brake splined sleeve (D). Remove brake counter disc
(E).
7. Secure the brake flange using a sling and hoist.
Unscrew the upper screw and lower stud bolt
(Figure 8-64). Remove the differential supporting flange
from the center housing, together with the bevel gear
backlash adjusting ring nut.
P0606
FIGURE 8-59
P0607
FIGURE 8-60
P0608 FIGURE 8-61
P0609
FIGURE 8-62
A0698
FIGURE 8-63
P0610
FIGURE 8-64
Reference Only