Maintenance work on the carrier
7.4 Fuel system
16.11.2018
Maintenance manual 3 302 756 en 7 - 31
GMK6400
7.4.3 Changing fuel filter 2
Spare parts
and
tools
– Receptacle, about 5 l (1.5 gal); à p. 2 - 4.
– Torque wrench for a torque of 25 Nm (18.4 lbf ft).
Prerequisites – The truck crane must be level and on outriggers; à Operating manual.
– The main boom must be fully raised; à Operating manual.
– The engine must not be running and must be secured against unauthor-
ised use; à p. 2 - 3.
Emptying the
fuel
line
• Place a receptacle underneath the filter.
• Close the valve – lever (1) at right angles to
the line.
• Open the drain plug (2) and let the
consumable drain out.
s
Designation Quantity GROVE part no.
Filter with gasket 1 03319653
O
Risk of environmental damage due to leaking consumables!
Always let consumables drain into suitable receptacles. Wipe up any
consumables that escape.
Store/dispose of consumables and any soaked equipment properly.
Ask about the applicable regulations.
To Next Page
Loading...
