MATHERS CONTROLS MicroCommander - PLAN THE INSTALLATION; 3.1 Actuator Location

To Next Page

To Previous Page

THIS PRODUCT IS INACTIVE!

Please contact Mathers Controls for support information.

Page ii

4.9Actuator ..........................................................................12

4.10 Connect Dc Power To Actuator..........................................13

4.11 Install Start Interlock Cable..............................................13

5. ADJUSTMENTS (ENGINES STOPPED) ......................................14

5.1ACTUATOR.......................................................................15

5.2Check Remote Controls And Station Transfer.........................15

5.3Push-Pull Cables ...............................................................16

5.3.1Transmission Cable Adjustment......................................17

5.3.2Throttle Cable Adjustment.............................................18

5.4Station Transfer................................................................19

5.5Start Interlock..................................................................19

5.6Throttle Pause ..................................................................20

5.7Final Check ......................................................................20

6. TESTS................................................................................21

6.1Adjustments To Check Underway.........................................21

6.1.1Full-Speed Setting........................................................21

6.1.2Proportional Pause On Direction Change ..........................22

6.2Control Head Tone ............................................................22

7. CONTROL OPTIONS..............................................................23

7.1High ('HI') Idle .................................................................23

7.1.1High 'HI' Idle Setting ....................................................24

7.2Primary Station Isolation Switch..........................................25

7.3Alarm Capability ...............................................................25

7.4Clutch Oil Pressure Interlock...............................................26

8. OPERATOR INSTRUCTIONS ...................................................27

8.1Control Type ....................................................................27

8.2Control Start-up................................................................27

8.3Engine Start.....................................................................27