Matrox 4Sight - Input Channels; Low-Pass Filter; Gain

Matrox Meteor-II /Multi-Channel grab section 117
Performance The video timing parameters (including those for progressive
scan) supported by the Matrox Meteor-II /Multi-Channel board
are as follows:
*Note that the maximum number of pixels per line that MIL
supports is:
Input channels
The Matrox Meteor-II /Multi-Channel frame grabber can
switch between two RGB or six monochrome video sources. You
can use the MIL-Lite MdigChannel() command to switch
between video sources (or channels).
Low-pass filter
The input low-pass filtering stage is used to limit high
frequency noise and aliasing effects at the input of the triple
A/D converter. The filter used on Matrox Meteor-II
/Multi-Channel is a 4th order Butterworth filter with a cutoff
frequency of 10 MHz.
Gain
Matrox Meteor-II /Multi-Channel has adjustable gains. This
allows you to optimize the video input signal range.
Max
Number of pixels / line (including sync and blanking) 4096*
Number of lines / frame (including sync and blanking) 4096*
Sampling rate (with external clock input, or in
line-locking mode)
30 MSPS
Pixels
Line
--------------
x Number of Lines 4 Mbytes≤