Advanced Configuration subscreen 159
WINDOWS CE BOOT OPTIONS section
■ 1 Mb DMA blocks:
Specifies reserved DMA (physically contiguous) memory.
Options:
❐ 0 to 127 blocks of 1 Mbyte (default is 4 blocks)
Refer to the table below for examples of how to reserve blocks
of DMA memory.
■ 64 KB DMA blocks:
Specifies reserved DMA (physically contiguous) memory.
Options:
❐ 0 to 15 blocks of 64 KB (default is 0)
Refer to the table below for examples of how to reserve blocks
of DMA memory.
■ Com Port:
This options allows you to set which port to use when
debugging Windows CE.
Options:
❐ 1 or 2 (default is 1)
Table 1: Reserving blocks of DMA memory
DMA Memory
Desired
Blocks from 1 Mb
DMA option
Blocks from 64KB
DMA option
4 Mbytes DMA 4 Blocks 0 Blocks
3.5 Mbytes DMA 3 Blocks 8 Blocks
To Next Page
Loading...
