Matrox 4Sight - Installing an Activemil;Activemil-Lite Application

Installing an ActiveMIL/ActiveMIL-Lite application 57
3. On the development computer, type at the prompt:
After typing the above sequence of commands, all the files
required to run Mfocus.exe should be installed on
Matrox 4Sight.
Installing an ActiveMIL/ActiveMIL-Lite
application
If your application is an ActiveMIL/ActiveMIL-Lite
application, you must follow the steps outlined in the
MIL/MIL-Lite documentation.
Note that to code and compile a MIL/MIL-Lite application, it is
necessary to first purchase and install a MIL/MIL-Lite package
on your development computer. Ensure that it has the same
version and build numbers as the redistribution version on the
Matrox 4Sight CD. Refer to the readme file on the Matrox
4Sight CD for details. Additionally, before calling the NET
SHARE command in step 2, you must add the following line:
for ActiveMIL, or
for ActiveMIL-Lite.
ActiveMIL controls can be used in applications built using
Visual C++ 6.0. They can also be used with applications that
are built using Visual Basic 6.0. Note, however, that you can
not perform remote debugging using Visual Basic 6.0.
NET USE R: \\4SIGHT\CROOT /USER:ADMINISTRATOR
COPY “C:\PROGRAM FILES\MATROX IMAGING\MIL\EXAMPLES\MFOCUS.EXE”
R:\MIL\EXAMPLES
COPY “C:\PROGRAM FILES\MATROX IMAGING\
DRIVERS\METEOR_II\DCF\RS170.DCF”
R:\MIL\DRIVERS\METEOR_II\DCF
COPY Z:\ACTIVEMIL\WINNT\*.* C:\WINNT\SYSTEM32
COPY Z:\ACTIVEMILLITE\WINNT\*.* C:\WINNT\SYSTEM32