Matrox 4Sight - Display Components

138 Appendix B: NTConfig Windows NT Embedded registry
Display components
Manually change some keys in the registry to change the
display driver resolution of your Matrox 4Sight unit. These
keys have been initialized to a default value. The display
resolution setting can be found in the following registry keys:
Registry Keys Setup
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Hardware Profiles\Current\
SYSTEM\CurrentControlSet
\Services\GX\Device0\
DefaultSettings.Xresolution
Set DWORD to one of the
following X resolution
values: 640, 800, 1024, 1280.
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Hardware Profiles\Current\
SYSTEM\CurrentControlSet
\Services\GX\Device0\
DefaultSettings.Yresolution
Set DWORD to one of the
following Y resolution
values: 480, 600, 768, 1024.
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Hardware Profiles\Current\
SYSTEM\CurrentControlSet
\Services\GX\Device0\
DefaultSettings.Vrefresh
Set DWORD to one of the
following vertical refresh
rate values: 60, 70, 72, 75.
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Hardware Profiles\Current\
SYSTEM\CurrentControlSet
\Services\GX\Device0\
DefaultSettings.BitsPixel
Set DWORD to one of the
following bits per pixel
values: 8,16.