Matrox 4Sight - Page 137

Manually configuring the Windows NT Embedded registry 137
Computer name
Manually change some keys in the registry to set the computer
name required by your LAN. This key has been initialized to a
default value and is available to all users on the computer. The
computer name setting can be found in the following keys:
Registry Keys (DAVICOM
Ethernet)
Setup
HKEY_LOCAL_MACHINE\
SYSTEM\
CurrentControlSet\
Services\DAVICOM2\
Parameters\
ConnectionType
Set DWORD to one of the
following values:
0 for auto-negotiation;
maximum output.
Forced with advertising:
2 for 10 Mbits half duplex
3 for 10 Mbits full duplex
8 for 100 Mbits half duplex
9 for 100 Mbits full duplex
Forced without advertising:
10 for 10 Mbits half duplex
11 for 10 Mbits full duplex
12 for 100 Mbits half duplex
13 for 100 Mbits full duplex
Registry Keys Setup
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Control\ComputerName\
ComputerName\
ComputerName
Set STRING to a string
representing the computer
name.
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Control\ComputerName\
ActiveComputerName\
ComputerName
Set STRING to a string
representing the active
computer name.
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Services\Tcpip\Parameters\
Hostname
Set STRING to a string
representing the computer
name of the development
computer.