Matrox 4Sight - Page 136

136 Appendix B: NTConfig Windows NT Embedded registry
Ethernet connection type
Manually change one key in the registry to set the Ethernet
connection type required by your LAN. This key has been
initialized to a default value and is available to all users on the
computer. The connection type setting can be found in the
following registry key:
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Services\DAVICOM2\
Parameters\TcpIp\
EnableDHCP
Set DWORD to 0 or 1. Use 1
to activate the DHCP.
\SYSTEM\CurrentControlSet\
Services\Tcpip\Parameters\
Domain
Set STRING to a string
representing the machine
domain name.
Registry Keys (INTEL
Ethernet)
Setup
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Services\E100E1\
Parameters\
Speed
Set DWORD to one of the
following values:
0 for auto-negotiation;
maximum output.
10 for forced without
advertising 10 Mbits
100 for forced without
advertising 100 Mbits
HKEY_LOCAL_MACHINE\
SYSTEM\CurrentControlSet\
Services\E100E1\Parameters\
ForceDpx
Set DWORD to one of the
following values:
0 for auto-negotiation;
maximum output
1 for forced without
advertising half duplex
2 for forced without
advertising full duplex